INSTRUCTIONS

OPSol® Mini-Clip 2.0 Flex

* NOTE FOR USER* The OPSol® Mini-Clip 2.0 has been painted a contrasting color for better visibility. 

IMG_9618.JPG
IMG_8613.JPG
IMG_8619.JPG

STEP 1

Put gun on SAFETY. Ensure firearm is unloaded with no shells in the magazine cylinder/tube or chamber. Make sure pump slide is in extended position.

STEP 2

Squeeze sides and insert the back flat end into the loading port at an angle, as shown.

STEP 3

Push down with one thumb and back with the other so that the OPSol® Mini-Clip 2.0 Flex™ is in flush to the rear and the bottom. Rack the slide a few times to ensure the OPSol® Mini-Clip 2.0 Flex™ is in position. It should not move. If it does move, remove the OPSol® Mini-Clip 2.0 Flex™ and repeat steps 1, 2, and 3.

IMG_8620.JPG

INSTALLED

IMG_8623.JPG

REMOVAL PROCEDURE:

Put gun on SAFETY. Ensure firearm is  unloaded with no shells in the magazine cylinder/tube or chamber. Retract the slide. Place your thumb into the ejection port and push the OPSol® Mini-Clip 2.0 Flex™ out .